HONDA TRX 450R Nerf Bar INSTALLATION AND REMOVAL INSTRUCTIONS

download
Parts List: Quantity Part 1 Nerf Bar Left 1 Nerf Bar Right 2 Hex Head Bolt, M10 x 70mm 2 Flat Washer, M10 2 Hex Head Bolt, M6 x 16mm 2 Flat Washer, M6 4 Net Clips 1 Net Set 2 Footpeg Washer 2. Preparation: a) Set/Lock rear parking brake on bike, turn gas petcock to ‘Off’ position and stand bike upright so that it is sitting on the rear grab bar. Make sure vehicle is secure and will not fall over while installing your new Nerf Bars. 3. Installation: a) Install Hardware & Web Strap per photo’s: NOTE: Loosely install all hardware and tighten when complete. Torque M10 Bolts @ 30 ft. lbs. Torque M6 Bolts @ 8 ft. lbs. REMOVE & REUSE OEM BOLTS TO ATTACH FOOT PEG. ATTACH FOOT PEG TO NERF SUPPORT USING M6 X 16MM HEAD BOLT AND WASHER. ATTACH NET CLIPS NOTE: FIRST SLIDE LEFT NERF WELDED TUBE INTO RIGHT NERF TUBE THEN, LOOSELY ATTACH FRONT NERF BARS TO THE A-ARMS USING OEM NUTS AND SUPPLIED M10 X 70MM BOLTS AND WASHERS