Corolla & Matrix 2005 – 2006 1ZZ-FE ENGINE NO START OR EXTENDED CRANK CONDITION
Download Some 2005 and 2006 model year Corolla and Matrix vehicles equipped with a 1ZZ–FE engine may exhibit a “no start” or “extended crank” condition. This may be caused by insufficient fuel pressure...
View ArticleLilac LS-18 Motorcycle Maintenance Standards
download CYLINDER AND CYLINDER HEAD MAINTENANCE ITEM STANDARD REPAIR LIMIT METHOD REMARKS Cylinder Bore 54 -0.01 54.1 Boring After boring honing should be performed Ovality 0.01 0.05 Boring After...
View ArticleHARLEY-DAVIDSON FLH/ FLT MODELS 1985-1996 REAR LOWERING KIT INSTALLATION...
download may encounter clearance problems when re-installing the saddlebags. Check for a minimum of 5mm. clearance to prevent damage to the saddlebags. Measure clearance in the recessed area in the...
View ArticleHONDA TRX 650 RINCON 4X4, TRX 680 Rincon BLADE HARDWARE MOUNTING REMOVAL AND...
download Push tube/ Swivel/ Blade Assembly Instructions 1. Install the blade swivel (15) onto the front of the push tube (14) using the 1/2″ shoulder bolt (4), two 1/2″ washers (5), and a 3/8″ Nylock...
View ArticleHONDA TRX 450R Nerf Bar INSTALLATION AND REMOVAL INSTRUCTIONS
download Parts List: Quantity Part 1 Nerf Bar Left 1 Nerf Bar Right 2 Hex Head Bolt, M10 x 70mm 2 Flat Washer, M10 2 Hex Head Bolt, M6 x 16mm 2 Flat Washer, M6 4 Net Clips 1 Net Set 2 Footpeg Washer 2....
View ArticleHonda CRF/ TRX 450R Camshaft Installation
download Break-in of this camshaft is important and you should adhere to all of the following instructions. It is also very important to use plenty of engine assembly lubricant, recommended is Coastal...
View ArticleHonda TRX 450R BoonDocker Nitrous System Installation Instructions
download This nitrous manifold greatly simplifies the way extra fuel is delivered that is needed for nitrous use. The carburetor vents are connected to this manifold, allowing the carburetor(s) to...
View ArticleS&S Connecting Rods Installation Instructions
download 1. Female rod crankpin end to mainshaft nuts – .030″ minimum clearance recommended. A. Install sprocket shaft and crankpin in driveside flywheel. Snug nuts only. Do not torque to final specs....
View ArticleHonda TRX 450R 2006 Rear Grab Bar INSTALLATION AND REMOVAL INSTRUCTIONS
download To avoid injury or damage to your ATV, read these instructions before installation. 1. Parts List: Item Part Name Description Qty 1 H062060 Grab Bar 1 2. Preparation: a) Lock rear brake on...
View Article2006-2008 Honda TRX 450R SR4 4 Stroke Carbon racing system INSTALLATION
download Removal of the stock exhaust, 1. Loosen stock tail pipe clamp (Fig 1) 2. Unbolt and remove stock muffler (Fig 2) 3. Remove stock header pipe (Fig 3) Installation Motoworks exhaust 1. Install...
View Article